THIS IS THE PLACE TO LIST AND SELL YOUR TRUCKS AND PARTS FREE!

Home of all dually trucks with the GMC/Chevy 3500HD series truck a point of interest.

By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please register for an account above!

You can appreciate the “beef” of the GMC/Chevy 3500HD trucks, a stripped rolling 3500HD chassis weighs more than a running C1500!

When posting on this site you won't have to explain what the 3500HD Beast is! ie 19.5 wheels, straight axle, 10 bolt wheels, 15000lbs GVW, 4 Wheel Disc Brakes etc

We are based in the U.S. If you are not from the U.S. or Canada (all IP addresses checked) you will be rejected. If you are a legit overseas applicant, contact me via email: borderdrop@yahoo.com


Welcome to the 3500HD.com forum created October 2009

Author Topic: Help identifying Rear cross-member?  (Read 271 times)

snowman4evr

  • Single Axle Driver
  • *
  • Posts: 4
Help identifying Rear cross-member?
« on: March 05, 2018, 02:16:14 PM »
Hi, Was wondering if anyone might know what this is called and where I might be able to get a new bushing for it.   This is on a 2002 C3500HD, with an 8.1 vortech with an alltec bucket.  Its definitely worn out/gone compared to the other side. 

MrC.

  • Single Axle Driver
  • *
  • Posts: 41
Re: Help identifying Rear cross-member?
« Reply #1 on: March 06, 2018, 07:11:41 PM »
Rear sway bar bushing.
Best bet is measure the outside diameter of the hole, and the bolt running through it.
I doubt its a factory replacement part.
MrC.

snowman4evr

  • Single Axle Driver
  • *
  • Posts: 4
Re: Help identifying Rear cross-member?
« Reply #2 on: March 06, 2018, 08:22:03 PM »
Thanks Mr. C.  I will get me a new battery for my calipers and do just that, see if napa can match it up.

SlowBoat

  • Single Axle Driver
  • *
  • Posts: 21
  • Location: Henagar, Alabama
Re: Help identifying Rear cross-member?
« Reply #3 on: March 10, 2018, 11:10:53 PM »
I would suggest that your best luck would be contacting Altec about a service part with the model number and serial number of the bucket bed on the truck.  It would be part of their installation package used to mount the bed to the chassis.
2001 Chevrolet 3500HD 159.5 WB, 8.1L, 5spd, 4.63
2000 GMC Sierra 3500HD 159.5 WB, 6.5L, 5spd, 5.13
1996 Chevrolet 3500HD 159.5 WB, 6.5L, AT
1995 Chevrolet 30HD Box Van, Bad gas engine, AT
1997 GMC Sierra 3500 CC, DRW, 6.5L, AT, 3.73

 


LINK SECTION - FEEL FREE TO SUGGEST ANY LINKS (YOURS INCLUDED).



DIESEL HUB
DIESEL PLACE
JEEP WRANGLER WIRING DIAGRAMS
MILLER TIG Welding Calculator
VINTAGE CHEVY/GM FORUM